[Apr-2023] The Best DCS-IE Study Guide for the DES-4122 Exam
DES-4122 certification guide Q&A from Training Expert ActualCollection
NEW QUESTION # 26
What is the Open Compute Project (OCP) card used for in a Dell EMC PowerEdge server?
- A. Flexibility to choose interconnects
- B. Provide a hot-swap component
- C. Fixed networking card
- D. Consume a PCIe slot
Answer: C
NEW QUESTION # 27
What is a requirement to operate GPUs in a Dell EMC PowerEdge R740 server?
- A. All GPU cards must be installed on the same riser card.
- B. All GPU cards must be of the same type and model
- C. All GPU cards must be installed at the same time
- D. All GPU cards must be of the same type but can be a different model
Answer: B
NEW QUESTION # 28
You must configure a BOSS card with 2 x 120GB drives for a Dell EMC PowerEdge server. What is the only supported mode?
- A. Non-RAID Mirroring
- B. RAID 1
- C. RAID 5
- D. RAID 0
Answer: B
NEW QUESTION # 29
You must configure a BOSS card with 2 x 120GB drives for a Dell EMC PowerEdge server. What is the only supported mode?
- A. Non-RAID Mirroring
- B. RAID 1
- C. RAID 5
- D. RAID 0
Answer: D
NEW QUESTION # 30
Refer to the exhibit.
Match each callout to the Dell EMC PowerEdge server model shown.
Answer:
Explanation:
NEW QUESTION # 31
Match each status LED indicator on the Dell EMC 14G PowerEdge server with its corresponding condition.
Answer:
Explanation:
NEW QUESTION # 32
For a temporary migration task the CPU core count on the Dell EMC PowerEdge R640 server needs to be reduced to 8 because the installed application will not work due to license restrictions. Use the simulator to apply the change so the application can be installed.
When you have finished using the simulator, click Next.
- A. A technician wants to
- B. Send us your suggestion for this simulation task.
Answer: B
NEW QUESTION # 33
What is the minimum number of components, beside the system board, required to POST?
- A. 1 PSU, 1 CPU, 1 DIMM, and PERC SAS controller
- B. 1 PSU and 1 CPU only
- C. 1 PSU, 1 DIMM, and 1 CPU only
- D. PSUs, CPUs, and DIMMs as configured in BIOS
Answer: C
NEW QUESTION # 34
A company that has very specific firmware requirements has acquired Dell EMC PowerEdge servers Any replaced parts of the type must match the original parts identically. The procedure must be as simple as possible with minimal risk.
What action should a technician take to help accomplish this goal?
- A. Configure servers to access the remote firmware repository
- B. Install and configure a repository manager
- C. Enable the Collect System Inventory On Restart (CSIOR) attribute
- D. Enable the Match Firmware of Replaced Part setting in the system BIOS
Answer: D
NEW QUESTION # 35
What is a characteristic of SupportAssist Enterprise on Dell EMC PowerEdge 14G servers?
- A. Includes onsite monitoring and automated collection of system state information
- B. Proactive, predictive, and automated support technology to enable faster resolution and reporting
- C. Dispatches technical support from Dell for all Dell servers, storage, and networking devices
- D. Used for customers that want monitoring of fewer than 1,000 server, storage, and networking devices
Answer: B
NEW QUESTION # 36
A technician is sent on-site to troubleshoot a server that produced an error message during the most recent POST, but then completed the POST and booted to the operating system. The user cannot remember the specific error and no entry was made in the error log relating to this error.
How can the technician find out what the error message was?
- A. Export the Server profile and analyze for any POST errors
- B. Access the Lifecycle Controller and view the last boot cycle video capture entry
- C. Access the iDRAC and view the last boot cycle video capture entry
- D. Reload the BIOS firmware
Answer: B
NEW QUESTION # 37
A technician needs to update the IDRAC license on a Dell EMC PowerEdge R740 server from Express to Enterprise. The server has the following components:
* 2x CPUs
* 384 GB RAM
* 6x 1 TB drives
* 1x PSU
The server is connected to active AC, but it is powered down, and it needs to stay powered down No errors are presently displayed How can the technician upgrade the license?
- A. Power on the server, then connect to the iDRAC and upgrade iDRAC license before powering down the server
- B. The license cannot be upgraded on a single PSU system
- C. Connect to the iDRAC GUI and upgrade the .DRAC license while the server .s powered down
- D. The license cannot be upgraded because the user will not allow the server to be powered on
Answer: B
NEW QUESTION # 38
Starting from which Dell EMC PowerEdge server hardware generation is the Micro SD card in the IDSDM/vFlash module supported?
- A. 12G
- B. 13G
- C. 14G
- D. 11G
Answer: B
NEW QUESTION # 39
What is a key distinction between 1DRAC8 and 1DRAC9?
- A. iDRAC8 default credentials are customer orderable
- B. iDRAC9 offers HTML5 based GUI
- C. iDRAC9 default credentials are root/calvin orderable only
- D. iDRAC8 offers HTML5 based GUI
Answer: A
NEW QUESTION # 40
A Dell EMC PowerEdge 14G server uses Intel OPTANE DC Persistent Memory in App Direct mode. What is the minimum size DIMM supported for this type of memory?
- A. 512 GB
- B. 64 GB
- C. 256 GB
- D. 128 GB
Answer: C
NEW QUESTION # 41
Which mobile devices are supported by Quick Sync 2.0 in 14G PowerEdge servers?
- A. Android devices only
- B. iOS, Android, and Windows Phone devices
- C. iOS devices only
- D. iOS and Android devices only
Answer: D
NEW QUESTION # 42
......
The Best EMC DES-4122 Study Guides and Dumps of 2023: https://exams4sure.actualcollection.com/DES-4122-exam-questions.html